Does the Krona dishwasher give an error code? When the icons light up on the display, the self-diagnosis system informs you of the breakdown. But how do you know where to look for a malfunction? To do this, the instructions indicate the decryption of all errors. You will also find an explanation of these symbols in our publication.
We will tell you how to fix the breakdown and restore the PMM.
We determine the value and ways to eliminate the errors of the Crohn dishwasher
As soon as a malfunction code is noticed on the display, do not rush to panic. If no other signs of damage are found, try resetting the error. What do we have to do:
- disconnect the equipment from the network for 10-15 minutes;
- start the car again and look at the screen.
Do the icons light up on the display? This means that this is not a system failure, but a technical problem that needs to be addressed. You can try to cope on your own.
Consider the malfunctions of the Krona dishwashers.
Error code | Value | Reasons for the appearance | How to fix the problem |
E1 | Water does not enter the hopper. | Aquastop protection turned on. It is triggered if a leak occurs. Located on the inlet hose. Access to water is blocked until the problem is resolved. | Carefully inspect the machine body, check the connections, the integrity of the hoses and nozzles. Look for water leaking from the door: the seal may be worn. Faulty elements replace. |
E2 | Water does not drain. | Why PMA Krona can show this error:
|
|
E3 | There is no heat. | The reasons:
| What to do:
|
E4 | The Aquastop system worked. | There is too much water in the dishwasher chamber. What is the reason:
| How to fix the situation:
|
E5 | Shorted the NTC sensor. | The thermostat does not give a signal. Cause:
| Diagnostics and change of thermistor or loop wiring. |
E6 E7 | The thermistor circuit has opened. | TEN is faulty. Heater contacts broken. | Inspect the heating element. Install new serviceable parts. |
E9 | There is no signal from the heater, or it does not work. | Heater breakage due to short circuit or other reasons. Most often, the flow element built into the circulation unit suffers from this. | Diagnostics details. How to replace the heater, read in a separate article. |
E10 | The dishwasher operates without heating. | The integrity of the drying is broken. | It is recommended to call the wizard or contact the service center. |
E11 | The technique works with cold water. There is no heat. | Faulty:
| Diagnostics and installation of serviceable parts is required if:
|
E14 | Incorrect operation of the flow sensor. | The consumable element is installed instead of the pressure switch. If error E14 occurs, then it does not receive control signals, although the circulation pump receives them. The reasons:
| What can you do:
|
E15 | Leakage protection tripped. | There was a water leak, or Aquastop failed. | Available Solutions:
|
E16 | An error occurred while taking water. | The reasons:
| Inspect the sensor. Wait until pressure is restored. Try installing a check valve. |
Knowing all the decoding errors of the PMA "Krona", you can try to independently find and fix the problem. Read how to disassemble a dishwasher in our article.